Intellinet Network IP Camera Betriebsanweisung PDF herunterladen (Seite 19)

NETWORK IP CAMERA User’s Guide

4.3.2 Assigning IP Address

Follow the below steps to assign IP address by using Hyper Terminal

① Execute “Hyper Terminal” on your PC

② Connect RS232 Cable to the serial port of PC that you have selected in ‘4.3.1 Configuring Hyper

Terminal’ and Network IP Camera serial port while Hyper Terminal is executed.

③ Supply the power to Network IP Camera.

④ After a while, the count down starts with the message “Press 'p' key to stop auto-boot or Load-

Default-Button under the NetCam for 3 seconds...”

At this time, press ‘p’ key. Then, [Network IP Camera Boot] prompt shows like the below image.

⑤ You can see Network Configuration while [Network IP Camera Boot] Prompt is running by

pressing ‘p’ key again.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 70 71

Keine Kommentare

Intellinet Network IP Camera Betriebsanweisung Seite 19